With the gradual strictness of our packaging and continuous changes in packaging, people have put forward higher demands for capping machines. The pressure of capping machines is strictly regulated, ranging from simple manual capping to mechanical automatic capping. Different levels of products such as high, medium, and low-end meet the needs of customers with different capping requirements.

Pursuing the stability of equipment and continuously improving the automation level of equipment, so that our screw cap can better serve people. Please ensure the trouble free operation time of our equipment. Make our capping machine more widely applicable to the entire packaging production line. When people buy capping machines, they tend to look for larger manufacturers and ensure the quality of their products.

Today, I have summarized four common problems and solutions for fully automatic capping machines:

1. The failure of automatic switches caused by drift in the operation of micro switches or photoelectric switches. For such faults, the working position of the position switch or photoelectric switch can be adjusted, or the switch can be replaced.

2. The short-circuit between the electric winding and the shell, as well as the short-circuit between the motor wiring and the grounding wire, causes an external current during startup. This fault can be used to check the motor and whether the relevant wires are loose

3. The acceleration time setting of the capping machine is too short and the electric shock capacity exceeds the capacity of the frequency converter, causing overcurrent faults during acceleration. The F001 value can be set for an appropriate duration, and the capacity of the motor cannot be changed arbitrarily.

4. The high voltage during operation caused by excessive fluctuations in power supply voltage can be easily solved by adding a reactor to the power input or reducing the power supply voltage appropriately.